All calculators

MCB Sizing

Load → MCB rating + typical cable

Reading 3

Type B for sockets/lights, Type C for motors, Type D rare.

%

Reading 100 %

Results

MCB rating
16A
Type
B
Design current Ib13.73 A
Power factor0.95 assumed for a kW load
Typical cable (not a sizing result)
1.5 mm² T&E — ref method C, no grouping, ambient or insulation correction. Confirm Iz ≥ In for the actual run. Indicative result.
System voltage230 V (single)
Diversity100%

What to buy — 3 items

16A Type B MCB (single module)
1 pc
16A 30mA Type B RCBO (alt. — additional protection)
1 pc
1.5mm² Twin & Earth cable
Order length to suit run
1 roll

Opens at Screwfix, Toolstation and the merchants for your trade. Free account, no card.

Take the whole job with you

A free account gets you the Gaffer for the awkward questions, a checklist for the job with every part on a shopping list, and quotes and invoices you can build and price up. Sending them out is Pro. No card needed.

Create your free account

Indicative design aids — the main figures and where each comes from are listed under "Figures based on" below.

An indicative breaker rating from the load. It does not size the cable, check earth fault loop impedance or disconnection times, or demonstrate compliance with BS 7671.

Figures based on

  • MCB ratings 6 to 100 A: BS EN 60898-1 preferred rated currents (6 to 125 A, 13 A included); the list here stops at 100 A. Edition and the list still to be confirmed against the published standard
  • Type B / C / D trip ranges (3–5, 5–10, 10–20 × In): BS EN 60898-1 instantaneous-tripping types (edition still to be confirmed)
  • Design current from kW: Geometry — I = P ÷ (U × pf) single-phase, P ÷ (√3 × U × pf) three-phase, times the diversity you set
  • Power factor 0.95 for a kW load: No source — workshop figure: a fixed estimating assumption, stated on the result. Enter the load in amps to avoid it
  • Typical cable by rating (reference method C): No source — workshop figure: a fixed starting point for clipped-direct cable with no correction factors, not a sizing result. Size the cable against BS 7671:2018+A4:2026 Appendix 4
  • Diversity / load factor: No source — workshop estimate, adjust to suit: an input (default 100%)

Indicative design aids. A standard is named with its edition; each is still to be checked against the published text. "Typical" means no standard sets it: check the bag, tin, data sheet or supplier named. "No source" means a workshop estimate: adjust to suit, or, where the box says it is fixed, a fixed estimating assumption.