Steel & Metal Weight
kg/m and total weight for plate, bar, box, tube, angle, beams
The label says which dimensions each shape uses. Unused fields are ignored.
Reading 50 mm
Reading 6 mm
Reading 6 m
Reading 1
Results
What to buy — 1 item
Opens at Screwfix, Toolstation and the merchants for your trade. Free account, no card.
Take the whole job with you
A free account gets you the Gaffer for the awkward questions, a checklist for the job with every part on a shopping list, and quotes and invoices you can build and price up. Sending them out is Pro. No card needed.
Create your free accountIndicative design aids — every figure and its source is listed under "Figures based on" below.
Figures based on
- Carbon steel density 7850: BS EN 1993-1-1:2005 §3.2.6
- Galvanised steel: No source — workshop figure: treated as steel, the zinc coating being 1–2% of the mass; an input (pick steel)
- Stainless 1.4301 7900 and 1.4401 8000: BS EN 10088-1:2023 physical properties
- Aluminium 2700: BS EN 1999-1-1:2007 §3.2.5
- Brass 8470, copper 8940, cast iron 7200: Typical — no standard tabulates them; supplier data sheets (Aalco; EN 1561 gives cast iron 7100–7300). Confirm against your supplier's data sheet
- Hollow and open sections: Geometry — sharp-corner area × density; published masses (BS EN 10210-2:2019, BS EN 10219-2:2019) allow for corner radii and land within about two per cent of it
- UB / UC / PFC: BS EN 10365:2017 serial sizes; the nominal mass is the designation's last number, and the SCI Blue Book P363 values differ from it by up to about 1%
Indicative design aids. "Typical" means no current standard sets it: follow your WPS and the consumable or gas data sheet named. "No source" means a workshop estimate: adjust to suit, or, where the box says it is fixed, a fixed estimating assumption.